C6 "Z06" Front License Plate Holder & Storage Bag - Buy Them Both and Save $$$.
We selected this frame over any other frame that we could sell.
High Quality - good looks - reasonably priced - you can buy with confidence.
Did you know more and more states are requiring front license plates? Presently 38 out of 50 states require front plates regardless of the car design.
Historically these laws have not been enforced. However, recent data demonstrates that the states are increasing enforcement and the fine amount.
Being avid Corvette owners ourselves, we prefer not to have a front plate on any Vette. Particularly at shows, events, and track days.
For the C-6 Z06, we have solved the problem, and it is easy - try it!
Installation instructions:
Parts List
- Mounting bracket
- Removable plate frame
- ¼-20 X 1.5” machine screw
- ¼ 20 Wing nut
- 2 - ¼-20 X 5/8” machine screws
Tools needed
- ¼” drive nut driver handle
- 7mm socket
- Flat bladed screwdriver
Installation:
- Jack up car and place on jack stands in such a manner to gain easy access to the bottom of the front bumper. Refer to user’s manual for correct jacking procedure.
- With the 7mm socket and nut driver handle remove and save the 7mm screws that hold the lower air dam to the fascia at the three slots on the left (driver’s) side of the car. Remove the 7mm screws on either side of the driver’s side skid plate at the back of the fascia and pull the fascia down slightly to gain access to the top of the skid plate.
- Using the 7mm screws mount the forward portion of the mounting bracket to the fascia behind the air dam but do not tighten the screws as you will need to adjust the mount left or right to get proper alignment.
- Push the bracket up against the skid plate and insert the machine screw through the two slotted holes in the mount. Install the wing nut and hand tighten.
- Replace the rear section of the fascia, install screws, and tighten.
- Insert frame through the lower air dam holes and into the mount bracket until it snaps in place. Noting where the alignment of the plate frame through the holes is equidistant from each side of the air dam holes, pull out the plate frame and tighten the front 7mm screws.
- Lower car off jack stands.
- Insert your license plate into the plate frame and install the ¼” 20 X 5/8” screws into the lower two holes in the plate frame.
- Installation is now complete
